Broadband-Hamnet™ Forum :: General
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Cannot access webgui.. 2013-12-30- 09:19:19 
W3JIM
Member
Joined: 2013-12-20- 05:54:42
Posts: 2
Location: 

I could not find a post on this topic.  If there is one please send me a link.

I have installed the firmware and configured through step #4. I have only one node.  My computer is connected to a LAN port still, the node is connected from the WAN port to my router (through a switch). I am trying to access the webgui.  Using localnode:8080 shows it being redirected to the status page.  The status page returns a 404.  When using http://callsign-1.local.mesh:8080/ it is getting a 404 without being redirected.

Now I may need some help on this but I would believe that the nodes would work within the net the using wireless interface. To connect to computers or the internet at my station, would I use only the LAN or WAN or both?

Thank you.

Jim
IP Logged
 Subject :Re:Cannot access webgui.. 2013-12-30- 09:47:28 
kd8rbh
Member
Joined: 2013-08-19- 22:05:20
Posts: 28
Location: 

You may try disconnecting the Ethernet cord from the PC for about 20sec. Try http://localnode:8080  What is the IP address of your computer? Is it dhcp or static?
IP Logged
Last Edited On: 2013-12-30- 09:49:21 By kd8rbh for the Reason
 Subject :Re:Cannot access webgui.. 2013-12-30- 09:50:08 
W3JIM
Member
Joined: 2013-12-20- 05:54:42
Posts: 2
Location: 
I moved the ethernet to the WAN port. I can access the webgui now using the ip:port. The OLSR cannot be access since the port is not open from the WAN. Haven't gotten to that point yet though. Thank you, Jim
IP Logged
 Subject :Re:Cannot access webgui.. 2013-12-30- 09:54:26 
kd8rbh
Member
Joined: 2013-08-19- 22:05:20
Posts: 28
Location: 
You will want to be connected to one of the lan ports. And set your IP address to automaticly obtain
IP Logged
Page # 


Powered by ccBoard


SPONSORED AD: