Broadband-Hamnet™ Forum :: Problems & Answers
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Cannot update/access my wrt54gl.. 2014-11-24- 01:04:52 
n9seo
Member
Joined: 2014-02-16- 09:19:01
Posts: 4
Location: 

Hi all,


I was wondering if theres somethign I am missing from the documentation regarding resetting these to 'default' mode of the meshnet firmware.  I have moved and a few months ago this was taken offline and now that I pulled it out to set backup I am unable to get into the device.  The only way was basically getting into the thing with failsafe mode.  Honestly I was trying to upload the 3.0 firmware which supercedes the 1.0 but for now the unit is dead, but least failsafe works


The unit boots up, when you connect a cable on the lan ports it gets an ip from the meshnet dhcp server.  Not sure where my disconnect is.  Sadly is I can open the port 8080 at dhcp server ip but it will not return a page and gives the generic cannot load page.


73 N9SEO
IP Logged
Last Edited On: 2014-11-24- 01:06:43 By n9seo for the Reason
 Subject :Re:Cannot update/access my wrt54gl.. 2014-11-28- 09:46:15 
n9seo
Member
Joined: 2014-02-16- 09:19:01
Posts: 4
Location: 
Hello mods, You can close this. I was able to reset it finally via failsafe with mtd.
IP Logged
 Subject :Re:Cannot update/access my wrt54gl.. 2014-11-28- 12:52:01 
KF5JIM
Future Astronaut
Joined: 2013-07-17- 12:13:36
Posts: 250
Location: Nederland
Glad you got it working! Happy Meshing! Closed.
IP Logged
My opinions and views expressed here are solely my own.
Page # 


Powered by ccBoard


SPONSORED AD: